MODIFICATION INFORMATION
Important information to know if you're considering customising or have already purchased a product that has been modified
.jpg)
NARROW FOOTPRINT
Steps with a reduced footprint have a larger height to base ratio (inc Narrow Aisle Pro range), MUST be used where supported both sides.
​
Use with in aisle racking only or where recommended by the manufacturer, fitted stabilisers.
​
For modified axles :
​
Do not lean out whilst the step is in operation.
​
Ensure that should you need to reach out, that the unit is firmly supported on BOTH sides.
MODIFIED PLATFORMS
Do not lean out whilst the step is in operation.
​
Ensure that should you need to reach out, that the unit is firmly supported on BOTH sides.
​
For cantilever platforms:
​
Use over equipment ONLY or where supported underneath.
​
Ensure braking system is on or castors have been locked into position.
EXITS
It's important that all exit gates and chains are closed and latched after use to prevent accidents.
PLATE FEET
Surface should be level & free from debris.
​
Move into position & bolt to floor (USE ALL BOLT HOLES).
SKID FEET
Ensure the surface is level & free from oil.
​
Lift slightly by handrails to move along.
FLUSH BACK WHEELS
Including inset wheels.
​
Use ONLY when pushed up against a vertical surface
Avoid (as much as possible) standing on the edge of the overhang.
​
Ensure braking system is activated or castors have been locked into position